DJI Matrice 30T
Quick Answer
The DJI Matrice 30T is a Matrice series DJI drone released in 2022, with 4,069 g max / 3,998 g EU C2, Zoom + thermal, DJI video modes, up to 41 min (1671 propellers), 15km, and O3 Enterprise connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
DJI Matrice 30T Comparison Snapshot
| Model position | Matrice series DJI drone, released 2022 |
| Flight profile | 4,069 g max / 3,998 g EU C2 takeoff weight; up to 41 min (1671 propellers) flight time |
| Camera profile | Zoom + thermal |
| Signal profile | O3 Enterprise; 15km max range |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
About the DJI Matrice 30T
DJI Matrice 30T adds a thermal camera to the M30 wide-angle, zoom and laser-ranging payload. DJI lists up to 41 minutes of flight and 36 minutes of hovering with 1671 propellers, or 38/34 minutes with 1676 propellers, under stated conditions. The aircraft is IP55 rated and uses O3 Enterprise transmission up to 15 km FCC or 8 km CE/SRRC/MIC in an unobstructed, interference-free setting.
Technical Specifications
| Dimensions (unfolded, excl. propellers) | 470×585×215 mm |
| Dimensions (folded) | 365×215×195 mm |
| Diagonal Wheelbase | 668 mm |
| Weight | 3770 ± 10 g (incl. two batteries) |
| Max Takeoff Weight | 4069 g (3998 g for EU C2 certification) |
| Max Horizontal Speed | 23 m/s (82.8 km/h) |
| Max Ascent / Descent Speed | 6 m/s ascent; 5 m/s descent; 7 m/s tilt descent |
| Max Flight Time | 41 min (1671 propellers); 38 min (1676) |
| Max Hover Time | 36 min (1671 propellers); 34 min (1676) |
| Max Wind Resistance | 12 m/s (43.2 km/h) |
| Max Service Ceiling | 5000 m (1671 propellers); 7000 m (1676 high-altitude) |
| Motor Model | 3511 |
| Propeller Model | 1671 / 1676 (high altitude) |
| Ingress Protection | IP55 |
| GNSS | GPS + Galileo + BeiDou + GLONASS (GLONASS with RTK module enabled) |
| RTK Positioning Accuracy | 1 cm + 1 ppm horizontal; 1.5 cm + 1 ppm vertical |
| Operating Temperature | -20°C to 50°C |
| Transmission | O3 Enterprise |
| Max Transmission Distance | 15 km (FCC) / 8 km (CE/SRRC/MIC) |
| Battery | TB30 Intelligent Flight Battery |
| Zoom Camera | 1/2" CMOS 48 MP, 21-75 mm (113-405 mm equiv.), f/2.8-f/4.2 |
| Wide Camera | 1/2" CMOS 12 MP, DFOV 84°, 4.5 mm (24 mm equiv.), f/2.8 |
| Laser Rangefinder | Yes |
| App | DJI Pilot 2 |
| Thermal Camera | Uncooled VOx microbolometer, DFOV 61°, 9.1 mm (40 mm equiv.), f/1.0, NETD ≤50 mK @ F1.0 |
| Data Source | DJI Matrice 30 Series User Manual v2.2 (official) |
Common Failure Modes
Symptoms: Cracked shell, bent arm, loose landing gear, abnormal vibration, or visible crash damage.
Likely areas: outer shell, arms, landing gear, motor mounts
Inspect the airframe before powering on and verify the exact replacement part against the model variant.
Symptoms: Motor start failure, rough spin, propulsion warning, overheating, or unstable hover.
Likely areas: motor, arm wiring, ESC board, power connectors
Check for impact damage, cable strain, and water exposure before replacing boards or motors.
Symptoms: Camera shake, gimbal overload warning, tilted horizon, calibration failure, or no camera image.
Likely areas: gimbal assembly, vibration board, camera module, gimbal flex cable
Avoid forcing the gimbal by hand and recalibrate after any gimbal or camera service.
Symptoms: Positioning drift, obstacle sensing warning, compass or IMU calibration prompt, or unstable low-altitude hover.
Likely areas: vision sensors, IMU, GPS/GNSS board, sensor flex cables
Clean sensor windows and verify calibration after shell, sensor, or board replacement.
Repair Notes
Confirm the exact model, variant, error message, and visible damage before selecting parts. Do not substitute parts from a similar model without verification.
Remove the battery before opening the aircraft. Check for moisture, corrosion, and overheated connectors before reconnecting power.
Flex cables and coaxial cables are fragile. Route them without sharp bends and inspect connector locks before closing the shell.
After replacing gimbal, vision, GNSS, IMU, shell, arm, or propulsion parts, run the required calibration and perform a controlled low-altitude test.
DJI Matrice 30T Parts Library
Parts Atlas is being mapped from verified Reboot Hub inventory. Model specs and repair guidance are available below.
Browse verified partsVerified Catalog Routes
Only current Reboot Hub product records or narrowly qualified catalog references are shown here. They do not establish repair-part fit, accessory compatibility, or included configuration; verify the live listing before purchase.