The DJI Mavic 3 Thermal is a Mavic series DJI drone released in 2022, with 920 g, 1/2-inch 48MP wide + 640x512 radiometric thermal, 4K/30fps, 45 min, 15 km, and O3 Enterprise connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
| Model position | Mavic series DJI drone, released 2022 |
| Flight profile | 920 g takeoff weight; 45 min flight time |
| Camera profile | 1/2-inch 48MP wide + 640x512 radiometric thermal; 4K/30fps video |
| Signal profile | O3 Enterprise; 15 km max range |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
The DJI Mavic 3 Thermal is best evaluated by its weight, camera system, flight time, range, and repairability. Use the specs and parts library on this page to compare it with other DJI models before buying or repairing.
Yes. Reboot Hub maps serviceable parts for the DJI Mavic 3 Thermal, including shell, arm, circuit board, flex cable, gimbal, and camera-related assemblies where available. Chip-level diagnosis is recommended when crashes, water damage, ESC faults, or gimbal errors are present.
Compare takeoff weight, sensor size, video mode, flight time, transmission system, parts availability, and warranty coverage. These factors affect image quality, travel rules, repair cost, and long-term ownership risk.
Where inventory is available, Reboot Hub lists OEM-pulled DJI parts and compatible assemblies for the DJI Mavic 3 Thermal. Match the exact model, part zone, and connector generation before ordering a replacement.
Check the serial number, activation status, battery health, gimbal movement, camera focus, sensor calibration, flight logs, shell damage, and whether the seller provides a functional test video or inspection report.
The DJI Mavic 3 Thermal is an enterprise-tier drone from the Mavic series, released in 2022. It is equipped with a dual-sensor payload featuring a 1/2-inch 48MP wide camera and a 640x512 radiometric thermal imager, alongside a maximum flight time of 45 minutes.
| Weight | 920 g |
| Dimensions Folded | 221 x 96 x 90 mm |
| Dimensions Unfolded | 347.5 x 283 x 107.7 mm |
| Max Flight Time | 45 min |
| Max Speed | 21 m/s |
| Max Transmission Distance | 15 km (FCC) |
| Camera | Modular payload support |
| Battery Model | DJI Mavic 3 Enterprise Battery |
| Battery Capacity | 5000 mAh |
| Charging System | DJI charger |
| GNSS | GPS + Galileo + BeiDou |
| Obstacle Sensing | Omnidirectional |
| Remote Controller Compatibility | DJI RC Pro Enterprise |
| App | DJI Pilot 2 |
Symptoms: Cracked shell, bent arm, loose landing gear, abnormal vibration, or visible crash damage.
Likely areas: outer shell, arms, landing gear, motor mounts
Inspect the airframe before powering on and verify the exact replacement part against the model variant.
Symptoms: Motor start failure, rough spin, propulsion warning, overheating, or unstable hover.
Likely areas: motor, arm wiring, ESC board, power connectors
Check for impact damage, cable strain, and water exposure before replacing boards or motors.
Symptoms: Camera shake, gimbal overload warning, tilted horizon, calibration failure, or no camera image.
Likely areas: gimbal assembly, vibration board, camera module, gimbal flex cable
Avoid forcing the gimbal by hand and recalibrate after any gimbal or camera service.
Symptoms: Positioning drift, obstacle sensing warning, compass or IMU calibration prompt, or unstable low-altitude hover.
Likely areas: vision sensors, IMU, GPS/GNSS board, sensor flex cables
Clean sensor windows and verify calibration after shell, sensor, or board replacement.
Confirm the exact model, variant, error message, and visible damage before selecting parts. Do not substitute parts from a similar model without verification.
Remove the battery before opening the aircraft. Check for moisture, corrosion, and overheated connectors before reconnecting power.
Flex cables and coaxial cables are fragile. Route them without sharp bends and inspect connector locks before closing the shell.
After replacing gimbal, vision, GNSS, IMU, shell, arm, or propulsion parts, run the required calibration and perform a controlled low-altitude test.
Parts Atlas is being mapped from verified Reboot Hub inventory. Model specs and repair guidance are available below.
Browse verified partsVerified batteries, controllers, goggles, propellers, and accessories mapped from Reboot Hub inventory for this model.
Official website: reboot-hub.com
Our official domain is reboot-hub.com. This is our only current official website for drone repair, pre-owned DJI drones, and OEM parts.
Reboot Hub is an independent repair parts and service provider. Reboot Hub is not affiliated with or endorsed by DJI.
