Garanti180 dages begrænset reservedelsgaranti. Se vilkår
DDP-levering
Der skal ikke betales importafgifter på berettigede ordrer.
DDP-levering, forklaret
For kvalificerede ordrer til personlig brug og destinationer vist ved kassen, arrangerer Reboot Hub levering som DDP. Gældende importafgifter og afgifter er inkluderet ved kassen eller håndteres gennem vores leveringsordning, medmindre kassen eller skriftlig bekræftelse siger andet.
Genuine OEM-pulled DJI Avata Motherboard. This is the central logic board removed from a first-generation DJI Avata, supplied for board-level replacement after the failed component and revision have been confirmed.
What does the DJI Avata Motherboard do?
The motherboard is the aircraft's main computer: it runs flight control and image processing and links to the transmission system and the other boards. For reference, the DJI Avata (2022) uses DJI O3+ (OcuSync 3.0+) transmission and has a rated range of 10km. The listing shows 4 original photographs of this exact part.
Common reasons owners replace it
The aircraft powers on but will not connect, or does not power on at all
Water or impact damage to the electronics
Persistent system errors that remain after firmware reinstallation
Included: One OEM-pulled motherboard in the photographed configuration.
Fitment and identification: For DJI Avata first generation only. Confirm the board outline, shielding, sockets, printed identifiers and every connector location before installation.
Condition: Removed original DJI component. Normal handling or removal marks may be present; the exact listing photographs define the supplied condition.
Not included: ESC board, RF board, GPS module, cables, heat-transfer material, motors and screws are not included unless shown.
Match delen, grænsefladen og tilstanden før bestilling.
For dele, controllere, kameraer, gimbals og tilbehør kontrollerer Reboot Hub den nøjagtige vare, delens identitet, synlige tilstand og kendte kompatibilitet i forhold til de oplysninger, der er tilgængelige for ordren. Bed os om at verificere pasform før betaling, når en komponent er model- eller revisionsspecifik.