The DJI Mavic Air 2 is a Air series DJI drone released in 2020, with model-specific takeoff weight, 1/2-inch CMOS, DJI video modes, model-specific flight time, 10 km, and DJI transmission system connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
| Model position | Air series DJI drone, released 2020 |
| Flight profile | Check takeoff weight before travel or regulatory use |
| Camera profile | 1/2-inch CMOS |
| Signal profile | DJI transmission system; 10 km max range |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
The DJI Mavic Air 2 is best evaluated by its weight, camera system, flight time, range, and repairability. Use the specs and parts library on this page to compare it with other DJI models before buying or repairing.
Yes. Reboot Hub maps serviceable parts for the DJI Mavic Air 2, including shell, arm, circuit board, flex cable, gimbal, and camera-related assemblies where available. Chip-level diagnosis is recommended when crashes, water damage, ESC faults, or gimbal errors are present.
Compare takeoff weight, sensor size, video mode, flight time, transmission system, parts availability, and warranty coverage. These factors affect image quality, travel rules, repair cost, and long-term ownership risk.
Where inventory is available, Reboot Hub lists OEM-pulled DJI parts and compatible assemblies for the DJI Mavic Air 2. Match the exact model, part zone, and connector generation before ordering a replacement.
Check the serial number, activation status, battery health, gimbal movement, camera focus, sensor calibration, flight logs, shell damage, and whether the seller provides a functional test video or inspection report.
The DJI Mavic Air 2 is a consumer drone from the Air series, released in 2020. It features a 1/2-inch CMOS sensor and supports a maximum transmission range of 10 km.
| Max Ascent Speed | 4 m/s (S Mode) |
| Max Descent Speed | 3 m/s (S Mode) |
| Max Flight Time (without wind) | 34 minutes |
| Max Hover Time (without wind) | 33 minutes |
| Max Flight Distance | 18.5 km |
| Max Horizontal Flight Speed | 19 m/s (S Mode) |
| Max Wind Resistance | 8.5-10.5 m/s (Level 5) |
| Max Pitch Angle | 35° (S Mode) |
| Operating Temperature Range | -10° to 40°C (14° to 104°F) |
| Hovering Accuracy Range | Vertical: |
| Satellite Systems | GPS+GLONASS |
| Internal Storage | 8 GB |
| Max Controllable Speed (tilt) | 100°/s |
| Operating Temperature | -10° to 40°C (14° to 104°F) |
| Sensor | 1/2" CMOS |
| Lens | FOV: 84° |
| ISO | Video: |
| Max Photo Resolution | 48 MP 8000×6000 pixel |
| Photo Modes | Single: 12 MP and 48 MP |
| Photo Formats | JPEG/DNG (RAW) |
| Video Resolution and Frame Rates | 4K Ultra HD: 3840×2160 24/25/30/48/50/60 fps |
| Video Formats | MP4/MOV (H.264/MPEG-4 AVC, H.265/HEVC) |
| Max Bitrate | 120 Mbps |
| Supported File Systems | FAT32 and exFAT |
| Available Downward Sensors | Dual Vision Sensors + Time of Flight Sensors (ToF) |
| Max Transmission Bitrate | 12 Mbps |
| Stabilization | 3-axis (tilt, roll, pan) |
| Mechanical Range | Tilt: -135° to 45° |
| Controllable Range | Tilt: -90° to 0° (Default) |
| Angular Vibration Range | ±0.01° |
| Forward | Precision Measurement Range: 0.35-22.0 m |
| Backward | Precision Measurement Range: 0.37-23.6 m |
| Downward | ToF Measurement Range: 0.1-8 m |
| Downward Auxillary Light | Single LED |
| Operating Frequency | 2.400-2.4835 GHz |
| Transmitter Power (EIRP) | 2.400-2.4835 GHz: |
| Transmission System | OcuSync 2.0 |
| Max Transmission Distance | 10 km (FCC), 6 km (CE), 6 km (SRRC), 6 km (MIC) |
| Live View Quality | 720p@30fps/1080@p30fps |
| Video Transmission Encoding format | H.265/H.264 (Auto-switches depending on encoding capabilities of device) |
| Remote Controller Transmission System | When used with different aircraft hardware configurations, DJI RC-N1 Remote Controllers will automatically select the corresponding firmware version for updating and support the following transmission technologies enabled by the hardware performance of the linked aircraft models: |
| Size | Folded: |
| Diagonal Distance | 302 mm |
| Max Service Ceiling Above Sea Level | 5000 m |
| Max Angular Velocity | 250°/s (S Mode) |
| Propellers | Quick release, low noise, folding |
| Compass | Single Compass |
| IMU | Single IMU |
| Voltage | 11.55 V |
| Charging Voltage Limit | 13.2 V |
| Color Profiles | D-Cinelike, Normal |
| Supported SD Cards | Supports a microSD with capacity of up to 256 GB |
| Zoom | Available |
| Left/Right | None |
| Obstacle Avoidance System | Advanced Pilot Assistance Systems (APAS) 3.0 |
| Latency (depending on environmental conditions and mobile device) | 120-130 ms |
| Max. Supported Mobile Device Size | 180×86×10 mm (Height×Width×Thickness) |
| Operating Current/Voltage | 1200 mA@3.6V (Android) |
| Charging Input | 100-240 V, 50/60 Hz, 1.3 A |
| Charging Output | Charging Port: 13.2 V⎓2.82 A |
| Rated Power | 38 W |
Symptoms: Cracked shell, bent arm, loose landing gear, abnormal vibration, or visible crash damage.
Likely areas: outer shell, arms, landing gear, motor mounts
Inspect the airframe before powering on and verify the exact replacement part against the model variant.
Symptoms: Motor start failure, rough spin, propulsion warning, overheating, or unstable hover.
Likely areas: motor, arm wiring, ESC board, power connectors
Check for impact damage, cable strain, and water exposure before replacing boards or motors.
Symptoms: Camera shake, gimbal overload warning, tilted horizon, calibration failure, or no camera image.
Likely areas: gimbal assembly, vibration board, camera module, gimbal flex cable
Avoid forcing the gimbal by hand and recalibrate after any gimbal or camera service.
Symptoms: Positioning drift, obstacle sensing warning, compass or IMU calibration prompt, or unstable low-altitude hover.
Likely areas: vision sensors, IMU, GPS/GNSS board, sensor flex cables
Clean sensor windows and verify calibration after shell, sensor, or board replacement.
Confirm the exact model, variant, error message, and visible damage before selecting parts. Do not substitute parts from a similar model without verification.
Remove the battery before opening the aircraft. Check for moisture, corrosion, and overheated connectors before reconnecting power.
Flex cables and coaxial cables are fragile. Route them without sharp bends and inspect connector locks before closing the shell.
After replacing gimbal, vision, GNSS, IMU, shell, arm, or propulsion parts, run the required calibration and perform a controlled low-altitude test.
15 serviceable parts in this zone.
4 serviceable parts in this zone.
3 serviceable parts in this zone.
0 serviceable parts in this zone.
Verified batteries, controllers, goggles, propellers, and accessories mapped from Reboot Hub inventory for this model.
Official website: reboot-hub.com
Our official domain is reboot-hub.com. This is our only current official website for drone repair, pre-owned DJI drones, and OEM parts.
Reboot Hub is an independent repair parts and service provider. Reboot Hub is not affiliated with or endorsed by DJI.
