The DJI Zenmuse XT S is a Zenmuse series DJI drone released in 2019, with 387g, DJI camera system, DJI video modes, model-specific flight time, model-specific range, and DJI transmission system connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
| Model position | Zenmuse series DJI drone, released 2019 |
| Flight profile | 387g takeoff weight |
| Camera profile | Check the model-specific camera module |
| Signal profile | DJI transmission system |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
The DJI Zenmuse XT S is best evaluated by its weight, camera system, flight time, range, and repairability. Use the specs and parts library on this page to compare it with other DJI models before buying or repairing.
Yes. Reboot Hub maps serviceable parts for the DJI Zenmuse XT S, including shell, arm, circuit board, flex cable, gimbal, and camera-related assemblies where available. Chip-level diagnosis is recommended when crashes, water damage, ESC faults, or gimbal errors are present.
Compare takeoff weight, sensor size, video mode, flight time, transmission system, parts availability, and warranty coverage. These factors affect image quality, travel rules, repair cost, and long-term ownership risk.
Where inventory is available, Reboot Hub lists OEM-pulled DJI parts and compatible assemblies for the DJI Zenmuse XT S. Match the exact model, part zone, and connector generation before ordering a replacement.
Check the serial number, activation status, battery health, gimbal movement, camera focus, sensor calibration, flight logs, shell damage, and whether the seller provides a functional test video or inspection report.
The DJI Zenmuse XT S is a radiometric 640×512 thermal payload with a 19 mm lens, ≤40 mK sensitivity and IP44 protection, for the Matrice 200 series.
| Type | Radiometric thermal payload |
| Dimensions / Weight | 105×101×83 mm / 387 g |
| Ingress Protection | IP44 |
| Supported Aircraft | Matrice 200 series V2 / Matrice 200 series |
| Thermal Imager | VOx 640×512 @25 Hz, 17 μm, NETD ≤40 mK, 19 mm lens |
| Scene Range | -40–150°C (high gain) / 100–550°C (low gain) |
| Gimbal | ±0.025° angular vibration |
| Data Source | DJI Zenmuse XT S User Manual (official) |
Symptoms: Horizon tilt, shaking image, gimbal overload warning, or motor whine.
Likely areas: gimbal motors, dampers, flex cables, IMU
Never force the gimbal by hand. Recalibrate after any transport shock or service.
Symptoms: Black feed, intermittent video, or payload not recognized by the aircraft.
Likely areas: SKYPORT/mount connector, coax and flex cables, main board
Inspect and reseat the detachable mount contacts first — connector wear is the most common cause on frequently swapped payloads.
Symptoms: Blurry frames, focus hunting, dead pixels, thermal NETD drift or measurement errors.
Likely areas: lens assembly, focus motor, image sensor, thermal shutter
Clean optics with proper tools only; thermal cameras need periodic flat-field calibration.
Symptoms: Fogged lens, corrosion at contacts, failures after rain or washdown.
Likely areas: seals, connectors, boards
Most payloads are IP44–IP54 at best — never submerge, and dry thoroughly before storage.
Confirm the exact payload model and firmware pairing with the aircraft before any parts decision — variants (e.g. H20 vs H20T) share bodies but differ internally.
Power off the aircraft before attaching or detaching the payload. Protect the SKYPORT contacts; cap the mount when not installed.
Use lens-safe tools only. For LiDAR windows, blow off dust before wiping to avoid scratching the coated glass.
After gimbal, IMU or camera service, run gimbal auto-calibration and verify stabilization and (for thermal/LiDAR) measurement accuracy before operational use.
Parts Atlas is being mapped from verified Reboot Hub inventory. Model specs and repair guidance are available below.
Browse verified partsVerified batteries, controllers, goggles, propellers, and accessories mapped from Reboot Hub inventory for this model.
Official website: reboot-hub.com
Our official domain is reboot-hub.com. This is our only current official website for drone repair, pre-owned DJI drones, and OEM parts.
Reboot Hub is an independent repair parts and service provider. Reboot Hub is not affiliated with or endorsed by DJI.
