The DJI Agras T10 is a Agras series DJI drone released in 2021, with 13kg, N/A, N/A, 19min (hover, light load), 5km, and OcuSync Agriculture connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
| Model position | Agras series DJI drone, released 2021 |
| Flight profile | 13kg takeoff weight; 19min (hover, light load) flight time |
| Camera profile | N/A; N/A video |
| Signal profile | OcuSync Agriculture; 5km max range |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
The DJI Agras T10 is best evaluated by its weight, camera system, flight time, range, and repairability. Use the specs and parts library on this page to compare it with other DJI models before buying or repairing.
Yes. Reboot Hub maps serviceable parts for the DJI Agras T10, including shell, arm, circuit board, flex cable, gimbal, and camera-related assemblies where available. Chip-level diagnosis is recommended when crashes, water damage, ESC faults, or gimbal errors are present.
Compare takeoff weight, sensor size, video mode, flight time, transmission system, parts availability, and warranty coverage. These factors affect image quality, travel rules, repair cost, and long-term ownership risk.
Where inventory is available, Reboot Hub lists OEM-pulled DJI parts and compatible assemblies for the DJI Agras T10. Match the exact model, part zone, and connector generation before ordering a replacement.
Check the serial number, activation status, battery health, gimbal movement, camera focus, sensor calibration, flight logs, shell damage, and whether the seller provides a functional test video or inspection report.
The DJI Agras T10, released in 2021, is part of the Agras series and positioned as an agricultural drone. It features a weight of 21.5 kg, a maximum transmission range of 5 km, and a flight time of 15 minutes, utilizing OcuSync Agriculture for transmission.
| Weight | 13 kg without batteries |
| Rated Takeoff Weight | 24.8 kg near sea level |
| Hovering Time | 17 min at 16 kg takeoff weight; 9 min at 24.8 kg takeoff weight |
| Max Operating Flight Speed | 7 m/s |
| Max Level Flight Speed | 10 m/s with good GNSS signal |
| Max Wind Resistance | 6 m/s |
| Max Takeoff Altitude | 4500 m |
| Dimensions | Unfolded: 1958 x 1833 x 553 mm; arms unfolded/props folded: 1232 x 1112 x 553 mm; folded: 600 x 665 x 580 mm |
| Spray Tank Volume | 8 L |
| Battery Model | BAX501-9500mAh-51.8V |
| App | DJI Agras |
| Data Source | DJI Agras T10 User Manual v1.4 (official) |
Symptoms: Cracked shell, bent arm, loose landing gear, abnormal vibration, or visible crash damage.
Likely areas: outer shell, arms, landing gear, motor mounts
Inspect the airframe before powering on and verify the exact replacement part against the model variant.
Symptoms: Motor start failure, rough spin, propulsion warning, overheating, or unstable hover.
Likely areas: motor, arm wiring, ESC board, power connectors
Check for impact damage, cable strain, and water exposure before replacing boards or motors.
Symptoms: Flow error, pump warning, uneven spray, nozzle blockage, or tank/payload warning.
Likely areas: pump, nozzle, flow sensor, tank, payload wiring
Clean fluid paths and confirm sealing before replacing electronics.
Symptoms: Positioning drift, obstacle sensing warning, compass or IMU calibration prompt, or unstable low-altitude hover.
Likely areas: vision sensors, IMU, GPS/GNSS board, sensor flex cables
Clean sensor windows and verify calibration after shell, sensor, or board replacement.
Confirm the exact model, variant, error message, and visible damage before selecting parts. Do not substitute parts from a similar model without verification.
Remove the battery before opening the aircraft. Check for moisture, corrosion, and overheated connectors before reconnecting power.
Clean pumps, nozzles, hoses, and flow sensors before assuming an electronic failure.
After replacing gimbal, vision, GNSS, IMU, shell, arm, or propulsion parts, run the required calibration and perform a controlled low-altitude test.
Parts Atlas is being mapped from verified Reboot Hub inventory. Model specs and repair guidance are available below.
Browse verified partsVerified batteries, controllers, goggles, propellers, and accessories mapped from Reboot Hub inventory for this model.
Official website: reboot-hub.com
Our official domain is reboot-hub.com. This is our only current official website for drone repair, pre-owned DJI drones, and OEM parts.
Reboot Hub is an independent repair parts and service provider. Reboot Hub is not affiliated with or endorsed by DJI.
