DJI Matrice 350 RTK
Quick Answer
The DJI Matrice 350 RTK is a Matrice series DJI drone released in 2023, with 9.2 kg max, Payload, DJI video modes, 55min, 20km, and O3 Enterprise connectivity. Reboot Hub uses this page as a technical reference for specs, compatible OEM parts, common repair planning, and inspected pre-owned buying checks.
DJI Matrice 350 RTK Comparison Snapshot
| Model position | Matrice series DJI drone, released 2023 |
| Flight profile | 9.2 kg max takeoff weight; 55min flight time |
| Camera profile | Payload |
| Signal profile | O3 Enterprise; 20km max range |
| Repair comparison | Compare shell, arm, ESC, flex cable, GPS, vision sensor, and gimbal availability before choosing between this model and another DJI drone. |
| Buying comparison | For pre-owned units, prioritize serial verification, battery health, gimbal calibration, flight test evidence, and warranty coverage over headline price alone. |
About the DJI Matrice 350 RTK
DJI Matrice 350 RTK is a 2023 enterprise aircraft with a DJI-listed 9.2 kg maximum takeoff weight. With one downward gimbal, DJI lists approximately 3.77 kg without batteries or 6.47 kg with two TB65 batteries; those configured weights are not the takeoff limit. DJI lists up to 55 minutes of flight without payload under its stated test conditions, IP55 protection that may decrease with wear, and O3 Enterprise transmission up to 20 km FCC or 8 km CE/SRRC/MIC in an unobstructed, interference-free environment.
Technical Specifications
| Dimensions (unfolded, no propellers) | 810×670×430 mm |
| Dimensions (folded, with propellers) | 430×420×430 mm |
| Diagonal Wheelbase | 895 mm |
| Weight | Approx. 3.77 kg without batteries; approx. 6.47 kg with two TB65 |
| Max Takeoff Weight | 9.2 kg |
| Single Gimbal Damper Max Payload | 960 g |
| Max Horizontal Speed | 23 m/s (82.8 km/h) |
| Max Ascent / Descent Speed | Ascent 6 m/s; descent 5 m/s vertical, 7 m/s tilt |
| Max Flight Time | 55 min (no payload, ~8 m/s, windless, to 0%) |
| Max Wind Resistance | 12 m/s (43.2 km/h) |
| Max Flight Altitude | 5000 m (2110s props, ≤7.4 kg); 7000 m (2112 high-altitude props, ≤7.2 kg) |
| Transmission | O3 Enterprise — 4 antennas, 2T4R |
| Max Transmission Distance | 20 km (FCC) / 8 km (CE/SRRC/MIC) |
| RTK Positioning Accuracy | 1 cm + 1 ppm horizontal; 1.5 cm + 1 ppm vertical |
| Ingress Protection | IP55 |
| GNSS | GPS + GLONASS + BeiDou + Galileo |
| Operating Temperature | -20°C to 50°C |
| Supported Gimbals | Zenmuse H20, H20T, H20N, P1, L1, L2 |
| Battery / Station | TB65 Intelligent Flight Battery; BS65 Intelligent Battery Station |
| Remote Controller | DJI RC Plus — 7.02" 1920×1200, 1200 nits |
| EU UAS Class | C3 |
| Data Source | DJI Matrice 350 RTK User Manual v1.2 (official) |
Common Failure Modes
Symptoms: Cracked shell, bent arm, loose landing gear, abnormal vibration, or visible crash damage.
Likely areas: outer shell, arms, landing gear, motor mounts
Inspect the airframe before powering on and verify the exact replacement part against the model variant.
Symptoms: Motor start failure, rough spin, propulsion warning, overheating, or unstable hover.
Likely areas: motor, arm wiring, ESC board, power connectors
Check for impact damage, cable strain, and water exposure before replacing boards or motors.
Symptoms: Camera shake, gimbal overload warning, tilted horizon, calibration failure, or no camera image.
Likely areas: gimbal assembly, vibration board, camera module, gimbal flex cable
Avoid forcing the gimbal by hand and recalibrate after any gimbal or camera service.
Symptoms: Positioning drift, obstacle sensing warning, compass or IMU calibration prompt, or unstable low-altitude hover.
Likely areas: vision sensors, IMU, GPS/GNSS board, sensor flex cables
Clean sensor windows and verify calibration after shell, sensor, or board replacement.
Repair Notes
Confirm the exact model, variant, error message, and visible damage before selecting parts. Do not substitute parts from a similar model without verification.
Remove the battery before opening the aircraft. Check for moisture, corrosion, and overheated connectors before reconnecting power.
Flex cables and coaxial cables are fragile. Route them without sharp bends and inspect connector locks before closing the shell.
After replacing gimbal, vision, GNSS, IMU, shell, arm, or propulsion parts, run the required calibration and perform a controlled low-altitude test.
DJI Matrice 350 RTK Parts Library
External
37 serviceable parts in this zone.
Circuit Boards
14 serviceable parts in this zone.
Flex Cables
10 serviceable parts in this zone.
Gimbal
7 serviceable parts in this zone.
Compatible Power & Accessories
Compatible batteries and accessories are being mapped from verified Reboot Hub inventory.