gimbal / OEM: CP.MA.00000401.01

DJI Mavic 3 - Hasselblad Gimbal Module

★★★★★
Expert / board-level diagnostics required
399.0
OEM replacement record / Fitment and repair notes
Ships worldwide from Hong Kong when stocked

Specifications

Primary sensor4/3-inch CMOS Hasselblad (L-format colour profile)
Secondary sensor1/2-inch CMOS (28× optical zoom)
Video5.1K/50fps (main), 4K/30fps (tele)
Stabilization3-axis mechanical (tilt, roll, pan)
Weight~95g (dual camera assembly)
ConnectorCustom FPC × 4

Common Failure Modes

Tele camera not detected
Inner FPC ribbon disconnected — common after firmware update issues
high
Primary camera oscillation
Hasselblad lens element misalignment from crash
high
Gimbal overload (both cameras)
Dual-gimbal balance calibration lost
medium
Colour banding in Hasselblad footage
CMOS sensor read circuit fault
low

Repair Notes

DJI Mavic 3 - Hasselblad Gimbal Module Service Notes

Inspect fitment, connector routing, screw length, and nearby modules before reassembly. If the aircraft reports calibration or startup errors after replacement, stop and run diagnostics before flight testing.

Related DJI Mavic 3 - Technical Wiki Parts

Need this part?

Buy the OEM part, or let Reboot Hub diagnose and install it for you.

Buy OEM Part → Book Installation