Zenmuse Series / Released 2014

DJI Zenmuse Z15-GH4 (HD)

Zenmuse Series Payload

About the DJI Zenmuse Z15-GH4 (HD)

Zenmuse Z15-GH4 (HD) is DJI’s 2014 three-axis HD gimbal specified for Panasonic GH4/GH3 and an Olympus 12 mm f/2.0 lens. DJI lists a 1.26 kg gimbal and a distinct 690 g reference GH4/lens load. The supported camera/lens and gimbal calibration matter more than the similar Z15 name; do not treat the GH4 model as interchangeable with BMPCC, 5D III or A7 versions.

Technical Specifications

Device ClassThree-axis HD camera gimbal; camera and aircraft are separate components
DJI-Listed CameraPanasonic GH4 or GH3
DJI-Listed LensOlympus M.Zuiko Digital ED 12 mm f/2.0
Gimbal Weight / Dimensions1.26 kg; 233 × 210 × 192 mm
Reference Camera/Lens Load690 g for Panasonic GH4, Olympus 12 mm f/2.0, battery and SD card; a listed setup, not an interchangeable maximum payload rating
Controlled Angle Accuracy±0.01°
Controlled RotationPan ±360° continuous; tilt +50° to −140°; roll ±40°
Maximum Controlled Rotation SpeedPan/tilt ±130°/s; roll ±30°/s
GCU / Input63 g GCU; 4S–12S LiPo input listed by DJI; follow the exact aircraft installation manual
Receiver ControlS-Bus/PPM receiver support; at least four spare receiver channels
Operating Temperature−10°C to 50°C
DJI-Listed Aircraft ContextMatrice 600 Pro support specifications list this Z15 Series HD gimbal; verify the correct mount, GCU, control path and firmware
Legacy SoftwareDJI product page states Zenmuse Assistant Software distribution/updates were discontinued from 2018-05-15
Official Sourceshttps://www.dji.com/zenmuse-z15-gh4-hd/info; https://www.dji.com/support/product/matrice600-pro (checked 2026-10-16)

Common Failure Modes

Gimbal initialization or control issue medium

Symptoms: Gimbal does not initialize, hold horizon or respond to control.

Likely areas: GCU power, receiver channels, calibrated camera/lens and gimbal mechanics

Check the exact Z15 model and DJI installation requirements before considering component service.

Video or shutter-control issue medium

Symptoms: Camera image or remote camera control is unavailable.

Likely areas: camera mode, HDMI/AV path, cable, power and control configuration

Distinguish camera and transmission faults from the gimbal; verify the documented camera/lens pair.

Repair Notes

Exact variant

Match the Z15 model label to its DJI-listed camera, lens, weight and control limits.

Legacy integration

Verify GCU, power, receiver channels, aircraft mount and supported software/firmware before fitting.

Service

A used camera, lens, GCU or mount is not presumed included; confirm components and written scope after inspection.

Product & Parts Mapping Status

No current Reboot Hub product route or model-specific Parts Atlas mapping is shown until exact evidence is verified. Use the primary technical source above for the current model boundary.

DJI Zenmuse Z15-GH4 (HD)

No current Reboot Hub product route or model-specific Parts Atlas mapping is shown until exact evidence is verified. Use the primary technical source above for the current model boundary.

DJI Zenmuse Z15-GH4 (HD) — frequently asked questions

Does DJI Zenmuse Z15-GH4 (HD) include the camera?
No camera inclusion is established by the gimbal specifications. DJI lists Panasonic GH4 or GH3 and Olympus M.Zuiko Digital ED 12 mm f/2.0 as the supported reference setup; verify the actual used-unit bundle.
What does 1.26 kg mean for DJI Zenmuse Z15-GH4 (HD)?
DJI lists 1.26 kg for the Z15 gimbal itself and separately lists a camera/lens reference load (690 g for Panasonic GH4, Olympus 12 mm f/2.0, battery and SD card). Neither figure is the aircraft takeoff weight.
Can I use any camera or lens with DJI Zenmuse Z15-GH4 (HD)?
DJI lists Panasonic GH4 or GH3 with Olympus M.Zuiko Digital ED 12 mm f/2.0 for this model. Confirm the exact calibrated camera/lens setup and mounting parts rather than assuming another Z15 variant is interchangeable.
Which aircraft does DJI list with DJI Zenmuse Z15-GH4 (HD)?
DJI’s Matrice 600 Pro support specifications name the Z15 Series HD gimbals including this model. Confirm the complete mount, GCU, controller and firmware integration before installation.
Modelldatabas
FPV / Avata
Neo
Flip
Spark / Tello