DJI MR1SS5 Remote Controller Wiki, Compatibility & P

Quick Answer

MR1SS5 is the 5.8 GHz controller variant for Mavic Mini and Mini SE; MR1SD25 is dual-band. DJI lists a 2,600 mAh battery and a 4 km FCC unobstructed link test for MR1SS5. Verify the model label and region.

Specifications

Controller typePhone-linked Enhanced Wi-Fi controller

ModelMR1SS5 (5.8 GHz variant); MR1SD25 is a distinct dual-band variant

Operating frequency5.725–5.850 GHz for MR1SS5

Controller link test4,000 m FCC or 2,500 m SRRC at 5.8 GHz, unobstructed and interference-free

Battery capacity2,600 mAh

Phone sizeMaximum length 160 mm, thickness 6.5–8.5 mm

ChargingMicro-USB; approximately 2 hours at up to 10 W per DJI charging guide

Compatible aircraftMavic Mini and Mini SE; match regional aircraft/controller version

Compatibility Notes

Compatibility depends on the exact aircraft model, transmission generation, firmware version, app/controller state, and regional binding behavior. Verify before purchase or flight.

DJI Mavic Mini DJI Mini SE

Inspection Checklist

Pairing and firmware

Confirm the controller can bind to the exact target aircraft and firmware generation before treating it as compatible.

Controls and calibration

Check stick centering, wheel/dial response, shoulder buttons, pause/RTH, record/shutter, and calibration behavior.

Ports, antennas, and charging

Inspect USB-C, phone/screen connection, antennas, charging port, speaker, and battery behavior for wear or damage.

Mount and phone connection

For screen controllers, check display brightness, touch response, storage, Wi-Fi, and app login. For phone controllers, check clamp and cable behavior.

Common Failure Modes

Stick drift or calibration failure

Off-center sticks, dead zones, or failed calibration can cause unsafe inputs and should be verified before flight.

Binding or firmware mismatch

A controller can power on but fail pairing if aircraft generation, firmware, region behavior, or binding state is unsupported.

Port or charging fault

USB-C, phone link, charging, or screen connection faults can block updates, live view, or reliable operation.

Button, antenna, or internal board issue

Impact or moisture can affect antennas, button boards, joystick modules, internal flex cables, or RF modules.

Repair Notes

Do not assume DJI controllers with similar names are interchangeable; verify aircraft support and firmware first.
After stick, button, or board work, run controller calibration and a controlled low-risk pairing test.
Inspect ports, antennas, and battery behavior before blaming the aircraft for connection or signal faults.
If the controller was bound to another account or aircraft, resolve binding and firmware state before hardware diagnosis.

Pre-Owned Buying Checks

Confirm exact controller model, aircraft compatibility, and firmware pairing path.
Check stick centering, buttons, scroll wheels, antennas, screen/phone mount, ports, and charging behavior.
Avoid controllers with water exposure, impact damage, failed calibration, binding uncertainty, or port damage.
For screen controllers, inspect display, touch response, app login, Wi-Fi, storage, and battery condition.